Precautions for the construction of the fence around the greenhouse:
1. Fixing method When fixing the fence around the greenhouse, use special clips to nail it on the exposed outer surface of the structure, crossbar, wall panel, etc. The fence around the greenhouse has been positioned as a whole, and the benches, columns, etc. are easy to
Corrosion damage occurs, it needs to be disconnected, and it is directly nailed in the clip. It looks relatively flat and strong. However, this fixing method can only partially work. If a risk accident occurs, it is very disturbing.
stable. Therefore, under normal circumstances, the cloth glue method is used. This method seems to be a bit lazy, but it is time-consuming, and the damage to the structure is very large.
2. Installation method of the fence around the greenhouse The fence around the greenhouse should use the I-shaped, triangular, and figure-eight installation methods, and try to install each side on the same plane to facilitate fixing in the center of the structure. Around the greenhouse
A good fence around the greenhouse should be placed in a suitable size and orientation, and the difference between the left and right lengths should not exceed 3 meters. Use special glue to fix the guardrail around the greenhouse, and do not fix it with nails. -General, Greenhouse Week
The side fence should first fix the skeleton inside the steel structure as the structural foundation, and then fix each group of rods. Regarding the fire-resistant crossbar, it is also necessary to ensure the standard recommended by the manufacturer, and first use the technical perforation
The method is fixed.
3. The quality of the clips - under normal circumstances, the thickness is the same as the surrounding fence net of the same number of cloth plastic greenhouses. The fixing materials of the above three kinds of greenhouse fences should be steel wire expansion bolts, but there are differences in the methods.
different. - Generally speaking, the expansion bolts are twisted and twisted into the iron wheel according to the pounds to fix, and the shuttle wire required to be used is a little thinner than the iron wheel with the same straight thread. Pre-coated clips are generally based on specific lines, through
Through physical methods, the clips are deformed accordingly and fixed to a certain position through the mold.
4. The choice of adhesive The adhesive is the same as that of yellow sand, and it is divided into outer layer adhesive and inner layer adhesive. . - Under normal circumstances, the adhesives are imported _ I industry-grade abs hard plastic.
